5
SPLASH! - PRODUCT COMPONENTS
COMPONENT DESCRIPTION
The Base Assembly is made up of several components described below:
Base Assembly -
Mounts to the pool deck or concrete boat dock.
Base Insert Stem -
Slides into the anchor sleeve that is installed on the pool deck or dock.
Housing -
ABS plastic cover shields base assembly components from weather. Must be in place prior to
installing the mast assembly.
Attachment Cover -
Slides down over housing to cover hardware (bolts and washers).
LiftOperator Control Box
- The unit controls all hoist operations identical
to the user hand set. Three cables connect to the bottom of the Control
Box to enable operation of the hoist. The largest connector is for the hand
control. Connector # 1 is for the motor cable (red stripe). Connector # 2
is for the actuator cable (green stripe).
Touchpad Control
–
The touchpad control arrow keys can be used in the event that the hand control is out of reach or
fails. Simply press and hold the arrow for the desired action for one movement at a time
– Up,
Down, Left, Right Releasing the Arrow stops movement.
CONNECTOR 1
(MOTOR CABLE)
CONNECTOR 2
(ACTUATOR CABLE)
