11
7. Remove twist tie and uncoil cable on top of housing. Insert plug (with red stripe) into connector #1
on Control Box. Insert cable into wire chase on front of mast, then push to close/lock wire chase.
Make sure plug is secure.
8. Remove twist-tie and uncoil actuator cable at bottom of mast.
9. Insert actuator cable plug
(green stripe with the “o” ring) into connector #2 on the Control Box.
Make sure plug is secure.
10. Remove and unwrap hand control from accessory carton. Insert plug into large connector on the
Control Box and hang hand control on handle. Make sure plug is secure.
11. Attach battery to Control Box. To remove battery, pull slightly away from mounting plate and lift
battery pack off of the Control Box.
12. Check up and down controls for proper operation - both touch pad and hand controls.
13. Check side to side controls for proper operation
– both touch pad and hand controls.
14. Check Emergency Stop button for operation/activation of internal sounder.
15.
Remove the battery and charge it fully before users begin to use the hoist.
16. Attach seat assembly with bolt and thumbnut in appropriate hole. For storage, seat can be
attached facing inward for less space.
17. Attach footrest to seat with bolts and thumbnuts.
POOL DECK INSTALLATION FOR THE SPLASH! LOCKING
ANCHOR
Ensure Locking Anchor has been installed in the correct location in the pool deck for proper hoist
operation. It is recommended that the anchor be installed by a person familiar with installing pool
deck equipment.
