700-9700
7.14.2022
31
STANDARD ACCESSORIES/OPTIONAL ACCESSORIES
The following items are included with all S.R.Smith pool lift models:
•
Seat Belt Assembly - Nylon water-resistant belt for added security.
•
Battery/Charger
– 24-volt rechargeable battery.
Optional accessories may be purchased for your multiLift2 lift through your Authorized Reseller. The
following accessories are available:
Console/Battery Cover
– P/N 910-1000T (Tan):
Protects battery and control unit from exposure to
moisture
P/N 910-1000S (Slate):
Protects battery and control unit from exposure to
moisture
multiLift2 Deck Anchor Kit P/N 300-6700A
–
Includes four (4) flush deck anchors.
New Construction Anchor Jig P/N 500-5000
–
Includes anchor jig, and hardware minus the flush deck
anchors. See anchor jig assembly info
Appendix B
on page 36.
MAINTENANCE and CLEANING
A maintenance program will prolong the life of your lift. Keep all electronic components clean and dry. Keep the
console/battery cover installed at all times to prevent moisture from collecting on the Control Box and battery.
Excessive moisture collection can affect battery and lift performance and could lead to battery failure and/or the
lift failing to operate.
If the lift is used outdoors, an optional full cover is available and recommended.
Owners of lifts should be aware of any applicable local, state/provincial, or federal/national regulations regarding
the inspection and or testing of lifts.
The following schedule shall be performed to ensure proper operation with the Daily items performed
before each use:
Maintenance Performed
Daily
Monthly
Check battery level before each use / Charge battery daily
Wipe Control Box and battery connection with a clean dry rag
Examine lift for any damage, loose or missing hardware
Test for normal operation
Make sure all cable connections are properly secured
Inspect lift frame, mast, support arm and seat assembly for rust
Cleansing Performed
– after each use
Rinse seat and seatbelt with fresh water between each use -
Cleanse seat and seatbelt with a disinfectant solution of 1:100
dilution of household bleach to fresh water and then rinse with
fresh water and dry entire lift daily. In the event of a
contamination incident such patient/user excreta - cleanse seat
and seatbelt immediately with the disinfectant solution*
Cleanse all battery connections with a nylon scouring pad
Cleanse all metallic surfaces with a cleaner wax to maintain the
finish of the lift
* When using the disinfection solution avoid direct contact with the skin and eyes. In the event of a contamination
incident - immerse the seat belt in the disinfection solution for 10 min. and then rinse thoroughly with fresh water.