12
FEATURES
BLADES
For maximum performance, it is recommended that you use
the 10 in., 24-tooth blade provided with your saw. Additional
blade styles of the same high quality are available for specific
operations such as ripping. Your local dealer can provide
you with complete information.
WARNING:
Do not use blades rated less than the speed of this tool.
Failure to heed this warning could result in personal
injury.
WARNING:
To prevent possible electrical hazards, have a qualified
electrician check the line if you are not certain that it is
properly wired.
POWER SWITCH
See Figure 3.
Your table saw is equipped with a power switch that has a
built-in locking feature. This feature is intended to prevent
unauthorized and possible hazardous use by children and
others.
TO TURN YOUR SAW ON:
n
With the switch key inserted into the switch, lift the switch
button to turn
ON.
TO TURN YOUR SAW OFF:
n
Press the switch button down to turn OFF.
TO LOCK YOUR SAW:
n
With the saw turned OFF, pull the switch key from the
switch and store in a safe, secure location.
OVERLOAD RESET BUTTON
See Figure 3.
This saw features an overload reset button located to
the right of the power switch. If your saw shuts off during
operation, turn the saw off and allow the motor to cool down
(approximately 3 minutes). Check all power cords for proper
connection. Push the reset button then turn the saw on.
NOTE: If the saw fails to start, contact an authorized service
center.
WARNING:
In the event of a power failure or when the tool is not in
use, turn the switch OFF and remove the switch key. This
action will prevent the tool from accidentally starting
when power returns.
SWITCH
OFF
SWITCH
ON
Fig. 3
WARNING:
ALWAYS make sure your workpiece is not in contact with
the blade before operating the switch to start the tool.
Failure to heed this warning may cause the workpiece to
be kicked back toward the operator and result in serious
personal injury.
WARNING:
To reduce the risk of accidental starting, ALWAYS make
sure the switch is in the OFF position before plugging
tool into the power source or resetting the overload reset
button.
SWITCH
KEY
REMOVED
OVERLOAD
RESET
BUTTON
