Rydeen BSS1, Owner'S Manual, Page: 6 / 13

5
V. Installation Guide
1. Sensor Installation
Installation requirements: sensors should be adhered to the inner corner of the bumper with
supplied Velcro. The angle should be between 20 to 25 degrees with the height ranging from
13-35 inches. (Fig.1-Fig.2)
Fig.1 Fig.2
Step1: Measuring method: Measure the rear bumper using the angle gauge to locate the 20 to 30
Degrees angle. (Fig.3-Fig.4)
The angle of the Microwave
radar sensors are between
20 to 25 Degrees.
The microwave sensors are only intended for
plastic bumpers.
Please note the BSS1 is NOT applicable for metal
bumpers.