EN
26
CAUTION!
Pay attention to the recoil of the branch after cutting. Cleaning the branches of a
standing tree (Fig. 26) Cut from the bottom up and finish from the top.
Fig. 26
CAUTION!
▪
Do not use an unstable support or ladder.
▪
Do not lose your balance.
▪
Do not cut above chest level.
▪
Always use both hands to hold the chainsaw.
▪
Do not cut a branch overhead.
11. MAINTENANCE
11.1 GENERAL
Before cleaning, inspecting or repairing your chainsaw, make sure the engine has stopped
and it is cold. Disconnect the spark plug to prevent accidental starting.
The user can only perform maintenance and service as described in this manual. Complex
interventions must be performed in an authorized service workshop.
Surface checks
Check for fuel leaks and loose parts or damage to the main parts, especially the handlebars
and the guide bar mounting. If defects are found, be sure to repair them before starting
operation.
11.2 CARBURETTOR ADJUSTMENT
The carburettor on your unit has been adjusted at the factory, but may require adjustments
due to changes in operating conditions.
Before adjusting the carburettor, make sure the air and fuel filter are clean.
Summary of Contents for DAC 456
