Main Support no.: +370 5 2045030
Polish Support no.: +48 22 2092532
Ukrainian Support no.: +380 947 107319
4
www.ruptela.com
2
Introduction
2.1
Purpose
The purpose of this document is to provide physical and technical data of the device, to explain how the
device works and how various states are indicated. It also includes instructions on how to prepare the
device for operation and configure it.
2.2
Acronyms
AC/DC
–
Alternating Current/Direct Current;
ACK
–
Acknowledged, a signal to acknowledge the receipt of data;
GLONASS
–
Global Navigation Satellite System;
GNSS
–
Global Navigation Satellite System;
GPRS
–
General Packet Radio Service;
GPS
–
Global Positioning System;
GSM
–
Global System for Mobile Communications;
IO
–
Input/Output;
LED
–
Light Emitting Diode;
PCB
–
Printed Circuit Board;
SELV
–
Safety Extra Low Voltage. A SELV circuit is a secondary circuit which is so designed and protected
that under normal and single fault conditions, its voltages do not exceed a safe value;
SMS
–
Short Message Service;
2.3
Legal Information
Copyright © 201
9 Ruptela. All rights reserved. Reproduction, transfer, distribution or storage of parts or
all of the contents in this document in any form without the prior written permission of Ruptela is
prohibited. Other products and company names mentioned in this document are trademarks or trade
names of their respective owners.
2.4
Document application
Given parameter values and various characteristics within this document apply only to the most recent
device hardware version.
2.5
Safety
This chapter contains procedures to help you safely use the FM device. By following these requirements
and recommendations, you will avoid dangerous situations. You must read these instructions carefully
and follow them strictly before operating the device!
All the associated (additional) equipment such as computers, batteries, sensors etc. shall meet
the requirements of standard EN60950-1.
Do not disassemble the device. If the enclosure of the device is damaged, or the insulation of
the wires is damaged, first disconnect the power supply cables from the power supply source.
All wireless data transferring equipment produces interference that may affect other devices
placed nearby.
The device can be installed or dismounted only by qualified personnel!
