Main Support no.: +370 5 2045030
Polish Support no.: +48 22 2092532
Ukrainian Support no.: +380 947 107319
14
www.ruptela.com
5.5
Antenna reconnection (FM-Eco4+ E S only)
In some cases you may need to disconnect the antenna from the device during installation. It is important
to disconnect and reconnect the antenna properly to maintain the integrity of the housing.
Follow these steps to disconnect the antenna:
1. Unscrew the housing screws and remove the top (see
the picture in section 5.1).
2. Carefully remove the PCB from the holding points.
3. Disconnect the antenna cable from the PCB.
4. Move the antenna gasket (1) out of the housing and
remove the antenna cable (2) from the housing.
Afterwards, follow these steps to reconnect the antenna:
1. Insert the antenna cable into the housing.
2. Reconnect the antenna cable to the PCB.
3. Mount the PCB onto the holding points (1) (2), while
placing the cable into its designated location (3).
4. Put the top on and screw in the screws (1). Carefully
insert the gasket (2) into its place, make sure it is
inserted tightly.
Important!
If step 4 is not completed, the housing will not be waterproof!
