Runco WindowWall, Installation Manual, Page: 117 / 196

Configuration Scenarios
Runco WindowWall Installation Guide 103
Scenario 1: Individual Inputs
Note: 3 x 3 wall with individual inputs
The simplest way to configure a Runco WindowWall system is where each LCD
displays the video from one and only one of the inputs. This scenario will be used
most often with a video processor such as a Magenta Processor.
Cabling
To cable a system for individual inputs, you should keep in mind that you will need to
be able to tell your video processor which inputs are in which position, so you will
probably want to put the displays in some logical order in the Quad Input Manager
Modules. If you have unused LCD connectors in your Quad Input Manager Module,
do not use those corresponding inputs. The above example shows the cabling for
this scenario. There is no need to cable the Loop Out or Dual Link In connectors for
this scenario.
Source Routing
There is a quick configuration for this scenario. In order to route the sources for
individual inputs, choose Individual Inputs for the
QUICK CONFIGURE BIG PICTURE
line
in the
WALL CONFIGURATION
menu.
A1
A 2
B1 B 2
A3
B3
C 1 C2 C 3
Source 1 Source 2 Source 3
Source 9
Source 4 Source 5 Source 6
Source 7 Source 8
A
Loop O ut
Dual Link In
Loop O ut
Dual Link In
Loop O ut
D ual Link In
Digital 1 Digital 2 Digital 3 D igital 4
B
D igital 1 Digital 2 Digital 3 D igital 4
D igital 1 Digital 2 Digital 3 D igital 4
C
Q uick C onfigure Big Picture Individual Inputs