Runco QuantumColor CineWide with AutoScope Q-1500d, Installation & Operation Manual, Page: 68 / 148

Installation
52 Q-1500d Series Installation/Operation Manual
PRE
L
IMINAR
Y
DHD
1. Select Calibration -> Adju s tment Mode
and set it to S econdary .
2. Select S ervice -> Te s t Video and choose
S econdary Alignment .
Projector (Align S econdary Image with
S creen)
1. Align the image to the screen by
adjusting the bottom primary lens
zoom, focus and H/V offset.
2. Tighten the bottom primary lens lock
screw.
3. Q-1500d/CineWide with
Auto
S cope only: Remove
anamorphic len s e s . Set the
AutoScope transport motor AC
switch to the “on” position.
Note: The default warp is 46 pixels on
the left and right sides (x) and 26 pixels at
the top and bottom (y). If more is
needed, use the “Image Alignment”
controls to increase it.
DHD
1. For a ceiling-mounted (inverted) and/or
rear-projection installation, select
S ervice -> Di s play Device ->
Configure -> In s tallation ->
Picture Orientation and set it as needed.
2. Select A s pect Ratio and set it to Cinema .
On a Q-1500d/CineWide with AutoScope,
this should position the anamorphic lens
transport in front of the primary lenses.
3. Select Calibration -> Adju s tment Mode
and set it to Primary .
4. Select S ervice -> Te s t Video and choose
Primary Alignment .
Projector
1. (Re-)in s tall anamorphic len s e s .
2. Align the primary image with the
screen by adjusting the top
anamorphic lens to produce the least
amount of distortion.
DHD
1. Select Calibration -> Adju s tment Mode
and set it to S econdary .
2. Select S ervice -> Te s t Video and choose
S econdary Alignment .
Projector
1. Align the secondary image to the
screen by adjusting the bottom
anamorphic lens to produce the least
amount of distortion.
DHD (Align S econdary Image with Primary
Image)
1. Select A s pect Ratio and set it to 16:9 .
2. Select Calibration -> Adju s tment Mode
and set it to S econdary .
3. Select Calibration -> Image Alignment
-> Corner Alignment , check the Primary
Te s t Pattern and S econdary Te s t
Pattern boxes and adjust corners.
4. Select Calibration -> Image Alignment
-> Midpoint Alignment , check the
Primary Te s t Pattern and S econdary
Te s t Pattern boxes and adjust midpoints.
Projector
No adjustment needed.
Note: The Primary lens image is usually
left un-warped. This provides the best
image quality and will be un-scaled for
1080p sources. You can adjust the
Primary image if needed, however, by
setting the
Adju s tment Mode to
Primary , checking the Primary Te s t
Pattern and S econdary Te s t Pattern
boxes and adjusting the corners and/or
midpoints prior to this step.
Table 3-6. Q-1500d Optical Alignment Procedure (with Anamorphic Len s e s ) (continued)