Runco QuantumColor CineWide with AutoScope Q-1500d, Installation & Operation Manual, Page: 103 / 148

Operation
Q-1500d Series Installation/Operation Manual 87
PRE
L
IMINAR
Y
Press MENU to exit test pattern mode.
Input Name s : You can give each input a descriptive name. For example, you may want
to change the default input name to the type of source component connected to it:
“VCR,” “DVD,” “Laptop” et cetera. Input names can be up to 12 characters long.
To edit an input name, select Input Names from the Service menu. Press or to select
an input and press ENTER . Use the or buttons to change a character; press
or to select a character to change. When you have finished editing the input name,
press ENTER or MENU .
To restore the default input name, press repeatedly to highlight that input name in the
“Restore” column. Then, press ENTER .
Di s play Device - Configure: The options in the Display Device - Configure menu allow
you to change the picture orientation, perform lens adjustments or access other,
display-device specific functions.
• In s tallation – Orientation: Select Picture Orientation from the Display Device -
Configure menu, then select Orientation to change the picture orientation to suit the
method of installation (Floor Front, Floor Rear, Ceiling Front or Ceiling Rear). Or, for
front-projection installations, use the
Auto setting to have the projector automatically
determine the orientation (floor or ceiling) using an internal sensor.
• Di s play Info.: Select Display Info. from the Display Device - Configure menu to see the
projector serial number.
• Diagno s tic s : Select Diagnostics from the Display Device - Configure menu, then
select Red, Green, Blue, Yellow, Cyan or Magenta to display only that color channel
(simulating a filter of that color). This can be useful for calibration or measurement
purposes.
To restore the normal picture (all colors), select White.
• Altitude: Select Altitude from the Display Device - Configure menu to control the
operation of the projector’s cooling fan.
In most cases, the default setting ( Auto ) will maintain the correct operating
temperature. If the display frequently turns off due to overheating, or in certain
high-altitude operating environments, you may need to change this setting to
High .
Primary Alignment
S econdary
Alignment
Dual Alignment
Use this pattern when aligning the
output from the projector’s
primary or secondary optical
engines (refer to
Power-Up
Sequence and Optical
Alignment Procedure
on
page 51). Select Dual Alignment
to have both optical engines
output this pattern.
Table 4-4. Te s t Pattern s and Their S ugge s ted U s age
Pattern S ugge s ted U s age
Input Name s
Restore
C o mp o s i t e 1
Composite 1
C o mp o s i t e 2
Composite 2
C o mp o s i t e 3 Composite 3
C o mp o n e n t
Component
H D 1
HD 1
H D 2
HD 2
S C A R T SCART
H D M I 1
HDMI 1
H D M I 2
HDMI 2
H D M I 3
HDMI 3
H D M I 4 HDMI 4