Runco Q-650i Series, Installation & Operation Manual

Page: 15 / 92

Q-650i Installation/Operation Manual 1
PRE
L
IMINAR
Y
1.1
About This Manual This Owner’s Manual describes how to install, set up and operate a Runco Q750i Series
LED Home Theater Projector.
Throughout this manual, the Runco Q-650i LED Home Theater Projectors are referred to
collectively as the “Q-650i.” Except where noted, the features and functions described in
this manual are common to all versions of this product.
Target Audience Runco has prepared this manual to help home theater installers and end users get the
most out of the Q-650i.
Runco has made every effort to ensure that this manual is accurate as of the date it was
printed. However, because of ongoing product improvements and customer feedback, it
may require updating from time to time. You can always find the latest version of this and
other Runco product manuals on-line, at www.Runco.com.
If You Have Comments
About This Manual... Runco welcomes your comments about this manual. Send them to info@runco.com.
Textual and Graphic
Conventions Text Conventions: The following conventions are used in this manual, in order to clarify
the information and instructions provided:
• Keypad button identifiers are set in upper-case bold type; for example, “Press EXIT to
return to the previous menu.”
• Computer input (commands you type) and output (responses that appear on-screen) is
shown in monospace (fixed-width) type; for example: “To change the aspect ratio to
Letterbox, type
op aspect = 1 <Enter>
. ”
• All keys with functional names are initial-capped, set in bold type and enclosed in angle
brackets. These keys are the following:
<Enter>, <Spacebar>, <Control>,
<Esc>
and
<Tab>
.
•
<Enter>
indicates that you may press either the RETURN or ENTER key on your
keyboard if it has both keys.
In addition to these conventions, underlining, boldface and/or italics are occasionally used
to highlight important information, as in this example:
1. Introduction
A carriage return must be used after each command or string.
Note