Runco LightStyle LS-12HBd, Installation & Operation Manual, Page: 96 / 152

Operation
80 LightStyle™ LS-12HBd Installation/Operation Manual
PRE
L
IMINAR
Y
• A s pect Ratio - Pa s te S etting s : To apply the Output Shift, Image Alignment and
Screen Masking settings on the clipboard to a different aspect ratio and/or screen, do
either of the following:
• Switch to another aspect ratio (for example, from 16:9 to Cinema).
• Switch from Screen 1 to Screen 2 or vice versa.
Then, select Paste Settings from the Copy/Paste Aspect Ratio menu. The new settings
are saved automatically.
Output S hift: The Left/Right, Up/Down, Width and Height controls in the Output Shift
menu are similar to those in the Input Position menu, except that they change the
characteristics of the output signal. These settings are saved independently
for each
a s pect ratio and s creen s election (refer to Screen on page 62).
• S creen Ma s king: This control adjusts the amount of cropping on each edge of the
output image. This differs from the regular Overscan control in two ways:
• It allows separate adjustments on each edge; and
• It is saved per aspect ratio, per screen (as opposed to per connector, per mode).
This is useful for installations where the aspect ratio of the screen doesn’t exactly match
the aspect ratio of the display.
Image Alignment: Use the controls in the Image Alignment menu to ensure proper image
geometry; that is, a perfectly rectangular projected image with no keystoning or pincushion.
For detailed instructions, refer to
Adjusting the Image Geometry on page 52.
Adju s tment Mode (during 3D Operation): By default, any command or control
message you send using the remote control, front-panel keypad or RS-232 interface is
acted upon by
both the Primary and Secondary scalers in the Dimension Digital
Controller. In some cases — for example, when using the lens controls or aligning the “left
eye” or “right eye” output images — you may need to address a command to only the
Primary or Secondary scaler. To do this, select Adjustment Mode from the Calibration
menu and set it to
Primary or S econdary . The Main Menu title changes to “Runco Video
(Pri.)” or “Runco Video (Sec.)” when you do this.
S pla s h Configure: Use the Splash Configure menu to control the appearance and
behavior of the “splash” screen that appears on the display upon power-up.
• Owner Name/I S F Calibrated/I S F Other: You can have the LS-12HBd display the
owner’s name, your name, the phrase “ISF Calibrated” and/or any other string, up to
30 characters in length.
Use the up or down cursor button to select a character. Use the right and left cursor
buttons to change the cursor position. Press
MENU when you have finished entering
text.
• S pla s h Timer: When you turn on the LS-12HBd, it projects a welcome screen with the
Runco and ISF logos, along with the personalized information you enter as described
above. Select Splash Timer from the Splash Configure menu to set the amount of time
for which this screen appears. The range is from 5 to 60 seconds, in one-second
increments. Press
or to set the timer, then press MENU .
The Secondary OSD menus are only visible during 3D operation. In
2D mode, you will only see the image from the Primary scaler,
regardless of this setting. If you want to adjust the Secondary scaler
while in 2D mode, you must use the built-in keypad and VFD on the
Dimension Digital Controller.
Note