Runco LightStyle LS-12HBd, Installation & Operation Manual, Page: 66 / 152

Installation
50 LightStyle™ LS-12HBd Installation/Operation Manual
PRE
L
IMINAR
Y
3.8
Turning on the Power 1. Power up your source components.
2. Turn on the main power switch at the rear of the Dimension Digital Controller.
3. Press the ON button on the remote control (or the ON/ S TANDBY ( ) button on the
Dimension Digital Controller front panel) to turn on the system. The vacuum
fluorescent display on the Dimension Digital Controller front panel briefly displays
“Initializing System,” followed by “Starting LS-12HBd.”
4. When the display is ready for use, the fluorescent display indicates the active source,
input resolution/frame rate and aspect ratio/screen; for example:
5. When the projector is turned on, the Active 3D Emitter turns on as well. The LEDs
display a red moving pattern while the emitter attempts to acquire a 3D signal and
until a signal is found.
If the emitter searches for a signal for longer than 60 seconds, a signal is assumed to
not be present.
6. Upon finding a 3D signal, all LEDs turn blue. Once the LEDs indicate a 3D signal, the
3D glasses can be used to experience 3D. For more information on using the Active
3D Glasses, refer to
Using the 3D Glasses on page 94.
HDMI 1
16:9/1 1080i/60
Current
S ource
A s pect Ratio/ S creen Input Re s olution/Frame Rate
LS-12HBd
1080p/60
S earching for 3D S ync S ignal 3D S ync S ignal Found