Ruijie RG-S6250-48XS8CQ Series, Hardware Installation And Reference Manual

Page: 7 / 46

Ruijie RG-S6250-48XS8CQ Series Switches Hardware Installation and Reference Guide Product Overview
- 5 -
External Ports
The RG-S6250-48XS8CQ provides the following ports:

Universal serial bus (USB) port: This port can connect with USB memory to save logs, host versions, warnings
and other diagnostic messages. Therefore, it is more convenient to upgrade the software version of the switch on
line and save the log information.
To protect the data and avoid device damage, use qualified USB flash disks of good brands. At the same time, the
local USB port is compatible with most of the USB controllers except some USB flash disks.
RG-S6250-48XS8CQ series switches support debugging, configuration, maintenance, management and host
software uploading of Console ports.

Console port: Use RS-232 interface electrical level and standard RJ45 connector. This interface is connected with
the serial port of terminal PC to perform system debugging, configuration, maintenance, management, and host
software uploading.

MGMT port: This is an out-band Ethernet port, which uses standard RJ45 connector. This interface is connected
with Ethernet port of a PC to perform program downloading.

SFP+ port: There are 48 10G SFP+ ports, which support optical modules and DAC copper cables (1000BASE-X
compatible).

QSFP28 port: There are 8 100G QSFP28 ports, which support optical modules and DAC copper cables. These
ports can also work in 4x10G mode.
Indicator
Indicator
Panel
Identification
Status Meaning
Switch status indicator
(Front panel/Back
panel)
Status
Off The system is not powered up.
Solid red
1) One of the modules of the system fails.
2) There are less than 3 fans.
3) The internal or partial temperature exceeds the
warning working temperature, and the switching
service resets.
Blinking green. The system is initializing.
Solid green The system is operational.
Solid yellow
1) The temperature gets to the warning threshold.
2) Only 3 fans are in the position.
3) One of the dual powers is not connected with the
AC power cord.
Switch locator indicator
(Front panel/Back
panel)
ID
Off Device location is disabled.
Solid blue Device location is enabled.
MGMT port indicator MGMT
Off The port is not connected.
Green The port is connected at 10M/100M/1000Mbps.
Blinking The port is transmitting or receiving data.
SFP+ port status 1F-48F Off The port is not connected.