Ruijie RG-S2600G-I Series, Cli Reference Manual

Page: 570 / 1192

CLI Reference MLD Snooping Configuration Commands
valid range is 1-3600.
Default
Settings 300s.
Command
mode Global configuration mode.
Usage
guidelines
The switch will remove the dynamic multicast router
interface from the router interface list if it fails to receive
the MLD general group query packets or the Ipv6 PIM
Hello packets within the aging timeout on this interface.
Examples
The following example shows how to set the aging time of
the dynamic multicast route port as 500s:
Ruijie(config)# ipv6 mld snooping dyn-mr-aging-time 500
ipv6 mld snooping query-max-response-time
Use this command to set t the maximum response time of the MLD general query packet. Use the no
form of this command to restore it to the default value.
ipv6 mld snooping query-max-response-time time
no ipv6 mld snooping query-max-response-time
Parameter
description
Parameter Description
time
Set the maximum response time of
the MLD general query packet, in
seconds. The valid range is 1-65535.
Default
Settings
10s.
Command
mode
Global configuration mode.
Usage
guidelines
Upon receiving the MLD general query packets, the
Layer-2 multicast device updates the aging timer of all
member ports. The time of the timer is the longest
response value. When the timer value decreases to 0, it
indicates that there is no member receiving the multicast
flow on the interface, and the Layer-2 device removes this
interface from the MLD Snooping forwarding list.
Upon receiving the MLD specific group query packets, the