CLI Reference
IP Address Configuration Commands
Configuration
Examples
The following is an example of disabling the IP source route.
no ip source-route
Related
Commands
Command
Description
N/A
N/A
Platform
Description
This command is supported on the Layer 2 switch only.
ip unnumbered
Use this command to configure an unnumbered interface. After an interface is
configured as unnumbered interface, it is allowed to run the IP protocol and can
receive and send IP packets. The
no
form can be used to remove this configuration.
ip unnumbered
interface-type interface-number
no ip unnumbered
Parameter
Description
Parameter
Description
interface-type
Interface type
interface-number
Interface number
Defaults
N/A.
Command
mode
Interface configuration mode.
Usage Guide
Unnumbered interface is an interface that has IP enabled on it but no IP address is
assigned to it. The unnumbered interface should be associated to an interface with
an IP address. The source IP address of the IP packet generated by an
unnumbered interface is the IP address of the associated interface. In addition, the
routing protocol process determines whether to send route update packets to an
unnumbered interface according to the IP address of the associated interface. The
following restrictions apply when an unnumbered interface is used:
An Ethernet interface cannot be configured as an unnumbered interface.
A serial interface can be configured as an unnumbered interface when it is
encapsulated with SLIP, HDLC, PPP, LAPB and Frame-relay. However, when
Frame-relay is used for encapsulation, only the point-to-point interface can be
configured as an unnumbered interface. X.25 encapsulation does not allow
configuration as an unnumbered interface.
You cannot detect whether an unnumbered interface works normally using the
ping
command, because no IP address is configured for the unnumbered
interface. However, the status of the unnumbered interface can be monitored
remotely using SNMP.
Summary of Contents for RG-S2600G-I Series
