Ruijie RG-S2600G-I Series, Cli Reference Manual

Page: 227 / 1192

CLI ReferenceInterface Configuration Commands VLAN Configuration Commands
native vlan vlan-id Specify the native VLAN.
Defaults The default allowed-VLAN list is all the VLANs, the default native VLAN is VLAN 1.
Command
mode
Interface configuration mode.
Usage Guide Native VLAN:
A trunk port belongs to one native VLAN. A native VLAN means that the untagged packets
received/sent on the trunk port belong to the VLAN. Obviously, the default VLAN ID of the interface
(that is, the PVID in the IEEE 802.1Q) is the VLAN ID of the native VLAN. In addition, when frames
belonging to the native VLAN are sent over the trunk port, they are untagged.
Allowed-VLAN List:
By default, a trunk port sends traffic to and received traffic from all VLANs (ID 1 to 4094). However,
you can prevent the traffic from passing over the trunk port by configuring allowed VLAN lists on a
trunk port .
Use the show interfaces switchport command to display configuration.
Configuration
Examples
The example below removes port 1/15 from VLAN 2:
Ruijie(config)# interface fastethernet 1/15
Ruijie(config-if)# switchport trunk allowed vlan remove 2
Ruijie(config-if)# end
Ruijie# show interfaces fastethernet1/15 switchport
Interface Switchport Mode Access Native Protected VLAN lists
--------- --------- --------- ---------
FigabitEthernet 1/15 enabled TRUNK 1 1 Disabled 1,3-4094
Related
Commands
Command Description
show interfaces Show the interface information.
switchport access Use this command to configure an interface as
a static access port and assign it to a VLAN.
Platform
Description
N/A
vlan
Use this command to enter the VLAN configuration mode. Use the no form of the command to
remove the VLAN.
vlan vlan-id
no vlan vlan-id
Parameter
Description
Parameter Description