Ruijie RG-S2600G-I Series, Cli Reference Manual

Page: 215 / 1192

CLI ReferenceInterface Configuration Commands Aggregate Port Configuration Commands
port will be load-balanced to the same outgoing port.
src-dst-ip-l4port
Traffic is distributed according to the source IP, destination IP, source L4 port and
destination L4 port. Packets with different source IP addresses, destination IP
addresses, source L4 ports and destination L4 ports are forwarded through
different ports, and packets with the same source IP address, destination IP
address, source L4 port and destination L4 port are forwarded through the same
port.
Defaults
Traffic is distributed according to the destination and source MAC addresses of the incoming packets.
Command
Mode
Global configuration mode.
Usage Guide Use show aggregateport load-balance command to display load-balancing algorithm configuration.
Configuration
Examples
Configure the MAC address-based load-balancing.
Ruijie(config)# aggregateport load-balance dst-mac
Related
Commands
Command Description
show aggregateport load-balance Use this command to display aggregateport
configurations.
Platform
Description
N/A
port-group
Use this command to assign a physical interface as a member port of an aggregate port. Use the no
form of the command to remove the membership from the aggregate port.
port-group port-group-number
no port-group
Parameter
Description
Parameter Description
port-group-number
Number of the member group of an aggregate port that is the
interface number of the aggregate port.
Defaults By default, the physical port does not belong to any aggregate port.
Command
Mode
Interface configuration mode
Usage Guide All the members of an aggregate port belong to a VLAN or configured to be trunk ports. The ports
belonging to different native VLANs cannot form an aggregate port.