Web-based Configuration Guide
L3 Management
96
Parameter
Description
Subnet Mask
Specify the subnet mask of the destination network. The
device matches the data packet based on the destination
address and subnet mask.
Outbound Interface
Specify the interface that forwards the data packet.
Next Hop
Specify the IP address of the next hop in the route for the
data packet
After a static route is created, you can find the relevant route configuration and reachability status in the static
route list. The
Reachable
parameter specifies whether the next hop is reachable, based on which you can
determine whether the route takes effect. If the value is
No
, check whether the outbound interface in the current
route can ping the next-hop address.
To delete or modify a static route, in
Static Route List
, you can click
Delete
or
Edit
in the last
Action
column;
or select the static route entry to be deleted, click
Delete Selected
to delete multiple static route entries.
6.4
Configuring a Static ARP Entry
Choose
Local Device
>
L3 Interfaces
>
ARP List
.
The device learns the IP address and MAC address of the network devices connected to its interfaces and
generates the corresponding ARP entries. Supports binding ARP mappings or manually specifying the IP
address and MAC address mapping to prevent devices from learning wrong ARP entries and improve network
security.
⚫
To bind a dynamic ARP entry to a static entry: Select the ARP mapping entry dynamically obtained in the
ARP List
, and click
Bind
to complete the binding.
⚫
To manually configure a static ARP entry: Click
Add
, enter the IP address and MAC address to be bound,
and click
OK
.
