RDC6563F Standalone Fiber Cutting Control System User Manual V2.0
55
SHENZHEN RUIDA TECHNOLOGY CO., LTD
doors. When this option is enabled, the system will
detect whether these devices generate this type of alarm.
In-position signal
enable
When the in-position signal is enabled, the in-position
signal is used to detect whether the following or rising is
in place when the Z-axis is followed; otherwise, the delay
is used instead of the bit signal. Generally set to in place
mode.
Enable engraving
function
—
3.6 File
3.6.1 Memory file
In the main interface, press the [File] button, the following interface pops up:
When entering the interface, the controller will automatically read the system's memory file,
the file name and the number of work pieces will be displayed on the list, and the selected file will
be previewed in the preview area in the lower right. When there are multiple files, press the up
and down keys to select a file, then the file will be previewed, and the graphic will be displayed at
the bottom right of the interface. When the [enter key is pressed, the file will be previewed on the
main interface, and the current file interface will be closed. If you want to cancel the preview,
press the [Exit] key.
When the number of files is large, you can page up/down. Press [Up] or [Down] to cycle
through the blue list between the file list, [Previous] and [Next]. When the blue cursor is stopped
at the [Previous] or [Next] option, press the [Enter] key to page through.
