RDC6563F Standalone Fiber Cutting Control System User Manual V2.0
18
SHENZHEN RUIDA TECHNOLOGY CO., LTD
2.1 System wiring diagram
The overall wiring diagram of the system as belowing:
2.2 Sensor Amplifier interface
Sensor is an amplifier connection interface
，
this interface is connects one end of the
15-meter cable to the height sensor and the other connects to the amplifier.
When installing the amplifier, make sure that the outer casing of the amplifier and the outer
casing of the cutting head are reliably connected; Use a multimeter to measure the conduction
state. The cutting plate needs to be in effective contact with the machine body, and the
impedance between the two is less than 10 ohms, otherwise the detection effect of the capacitive
sensor will be affected.
Important:
Do not disassemble or cut the 15-meter amplifier cable.
Otherwise, the amplifier may be damaged or the signal may be
unstable.
2.3 Main power input interface
Main power input interface definition, as shown in the following table
：
