RDV3040-PCIVisionCut operation manual V1.0
SHENZHEN RUIDA TECHNOLOGY
2
1.1 VisionCut introduction
VisionCut system is designed exactly for Mark cutting. This system is based on the RDC3020G
motion controller. This controller is based on DSP+FPGA and has high performance in motion
control and laser control.
This laser cutting system can interfaces with CO2 tube ,YAG tube and Fiber tube. Servo motor
and step motor can connect to RDC3020G motion controller. RDC3020G has the special IO for
Limit switch and Home switch .
The following is the construction of the VisionCut. Picture 1-2 shows the electrical connections of
the VisionCut in detail.
Picture 1-1: Vision Cutting System
