RUGGEDCOM RSG2488
User Guide
Chapter 5
Setup and Configuration
Deleting an SNMP Group
171
Parameter
Description
The minimum level of security reqwuired in order to gain the access rights allowed by
this entry. A security level of noAuthNoPriv is less than authNoPriv, which is less than
authPriv.
ReadViewName
Synopsis:
{ noView, V1Mib, allOfMib }
Default:
noView
This parameter identifies the MIB tree(s) to which this entry authorizes read access. If
the value is noView, then no read access is granted.
WriteViewName
Synopsis:
{ noView, V1Mib, allOfMib }
Default:
noView
This parameter identifies the MIB tree(s) to which this entry authorizes write access. If
the value is noView, then no write access is granted.
NotifyViewName
Synopsis:
{ noView, V1Mib, allOfMib }
Default:
noView
This parameter identifies the MIB tree(s) to which this entry authorizes access for
notifications. If the value is noView, then no access for notifications is granted.
4. Click
Apply
.
Section 5.6.3.3
Deleting an SNMP Group
To delete an SNMP group, do the following:
1. Navigate to
Administration > Configure SNMP > Configure SNMP Access
. The
SNMP Access
table
appears.
Figure 132: SNMP Access Table
2. Select the group from the table. The
SNMP Access
form appears.
