50
Operating and Troubleshooting the 7781CM
Switching LEDs to CM Mode
Using the AP’s Web Interface to Switch LEDs to CM Mode
This procedure is only available if the AP is in standalone mode.
1.
Log in to the AP’s Web interface as described in
“Logging Into the AP’s Web Interface
2.
On the menu, click
Administration
>
LED Diagnostics
.
Figure 26.
The LED Diagnostics page
3.
In
LED Mode
, click one of the following modes:
•
(1) Cable Modem
: Click this option if you want the LEDs to stay in
CM Mode
until
you switch them to another mode.
•
(3) Alternate between modes 1 and 2 at 30 second period then disabled after
60 minutes
: Click this option if you want the LEDs to switch to
CM Mode
as soon
as you click
Save
, and then alternate with
AP Mode
every 30 seconds.
4.
Click
Save
.
5.
Check the access point for a white LED. This indicates that the LEDs are now in
CM
Mode
.
NOTE:
If you see a far-right
green
LED, this indicates that the LEDs are still in
AP Mode
.
You have completed switching the LEDs to
CM Mode
using the access point’s Web
interface.
Summary of Contents for ZoneFlex series
Page 2: ......
Page 6: ...iv ...
Page 62: ...56 What to Do Next Reading Related Documentation ...
Page 67: ...61 Appendix B Rebooting and Resetting the 7781CM ...
