55
Switching LEDs to Cable Modem Mode
Using SNMP to Switch LEDs to CM Mode
Figure 33.
The LED Diagnostics page
Using SNMP to Switch LEDs to CM Mode
Use SNMP to set MIB values on the CMAP that control the LED mode.
NOTE:
Before starting this procedure, you must first obtain the related MIBs from Ruckus
Wireless. Contact your authorized Ruckus Wireless sales representative or Ruckus Wireless
Support. Visit
http://support.ruckuswireless.com/contacts
for Ruckus
Wireless Support contact information.
1.
Start your MIB browser.
2.
Load the Ruckus Wireless MIBs onto the MIB browser.
3.
In the MIB browser, specify the IP address of the 7761-CM AP that you want to
configure.
4.
Find the OID
1.3.6.1.4.1.25053.3.1.4.7.3
(ruckusZF7761CMControlLED).
5.
Set the value to the following:
•
1
: ledPerCM(1)
– After you set the LEDs to
CM Mode
, they stay in
CM Mode
until you switch them to another mode.
6.
Check the CMAP for a white LED. This indicates that the LEDs are now in
CM Mode
.
Summary of Contents for ZoneFlex 7761-CM
Page 2: ......
Page 6: ...iv...
Page 78: ...72 Troubleshooting Contacting Ruckus Wireless Support...
