47
Verifying the Connection
Step 2: Attach the Dynamic Bracket to the Wireless Bridge
11
Verifying the Connection
Once you have completed the hardware installation and network configuration for both
Wireless Bridges, verify the connection and signal integrity between the bridge pair using
the following procedure:
1.
Access the root bridge Web interface by entering its IP address into a Web browser
on a computer connected to the same switch that the root bridge is connected to.
2.
On the
Status > Wireless
page, check to make sure the non-root bridge is listed under
the
Connected Device
section.
Figure 38.
Viewing connected device from the Web interface
3.
On the
Status > Wireless
page, click the SpeedFlex icon
to launch the SpeedFlex
Wireless Performance Test.
4.
Click Start to begin testing
5.
Once the test is completed, the following result page is displayed.
Summary of Contents for ZoneFlex 7731
Page 2: ......
