Ruckus Wireless ZoneFlex 7731, Getting Started Manual, Page: 17 / 56

13
Preparing the Wireless Bridge Pair for Installation
Configure the Root Bridge
Figure 6. Connect the Ethernet cables and power adapter to the PoE injector
You have completed connecting the Wireless Bridge to a PoE power source.
Use DC Power
To use DC to power the Wireless Bridge, you need to connect a DC cable (not supplied
with the Wireless Bridge) to the DC terminal block.
1. Take out the DC terminal block from the small plastic bag that contains the bottom
cover of the Wireless Bridge.
2. Connect the DC cable’s ground wire to V- terminal. If you are looking at the terminal
block with the wiring terminal screws on top, the V- terminal is on the
left side .
3. Connect the DC cable’s +12v DC wire to the V+ terminal. If you are looking at the
terminal block with the wiring terminal screws on top, the V+ terminal is on the
right
side .
Figure 7. Connect the ground wire to the V- terminal and the +12v DC wire to the V+
terminal
To Admin
Computer
To Bridge
To AC Power Source
Ground Wire to
V- Terminal
12V DC Wire to
V+ Terminal