Ruckus Wireless ZoneDirector 3000, User Manual, Page: 121 / 430

Configuring Self Healing Options
Tunnel Configuration
ZoneDirector 9.8 User Guide, 800-70599-001 Rev B
121
Figure 64. Enabling active client detection
A low severity event is now triggered each time a client connects with an RSSI lower
than the threshold value entered. Go to
Monitor > All Events/Activities to monitor
these events.
Tunnel Configuration
Only WLANs with Tunnel Mode enabled are affected. See “Advanced Options” in
the WLAN configuration section for information on enabling Tunnel Mode.
To configure data encryption and filtering for tunneled WLANs:
1 Go to Configure > Services .
2 Scroll down to the bottom of the page and locate the Tunnel Configuration
section.
3 Enable the check boxes next to the features you want to enable:
•
Enable tunnel encryption for tunneled traffic:
By default, when WLAN
traffic is tunneled to ZoneDirector, only the control traffic is encrypted while
data traffic is unencrypted. When this option is enabled, the Access Point will
decrypt 802.11 packets and then use an AES-encrypted tunnel to send them
to ZoneDirector.
•
Block multicast traffic from network to tunnel
: Prevents [all/non-well-
known] multicast traffic from propagating on the tunnel.