4.
Click the
Apply
button in the same section to save your changes.
ZoneDirector enables AeroScout RFID tag detection on all its managed APs that support
this feature.
NOTE
Tag locations are not accurate if the 2.4 GHz band is noisy or if the AP setup is
not optimal (according to AeroScout documents). For more information on AeroScout
Tags and the AeroScout Engine, refer to your AeroScout documentation.
Ekahau Tag Detection
Utilizing Wi-Fi wireless network as an infrastructure, the Ekahau Real Time Location
battery-powered devices that can be mounted on equipment or carried by personnel,
and send out periodic Ekahau Blink frames. Wi-Fi Access Points receive and forward
the Ekahau Blink frames to the Ekahau RTLS Controller, which calculates accurate
locations for the tags.
To enable Ekahau tag detection on ZoneDirector:
1.
Go to
Configure
>
Services
.
2.
Scroll down to the
Ekahau Settings
section (near the bottom of the page).
3.
Select the
Enable Ekahau tag detection
check box.
4.
Enter the
Ekahau Controller IP address
and
Ekahau Controller Port
.
5.
Click the
Apply
button in the same section to save your changes.
ZoneDirector enables Ekahau tag detection on all its managed APs that support this
feature.
Active Client Detection
Enabling active client detection allows ZoneDirector to trigger an event when a client
with a low signal strength joins the network.
To enable active client detection:
1.
Go to
Configure
>
Services
, and scroll down to the
Active Client Detection
section.
2.
Click the check box next to
Enable client detection ...
and enter an RSSI threshold,
below which an event will be triggered.
3.
Click
Apply
to save your changes.
A low severity event is now triggered each time a client connects with an RSSI lower
than the threshold value entered. Go to
Monitor
>
All Events/Activities
to monitor
these events.
83
Ruckus Wireless ZoneDirector™ Release 10.0 User Guide
Configuring Security and Other Services
Ekahau Tag Detection
