these indoor-only channels when SmartSelect or Auto Channel selection is used, unless
the administrator configures the AP to allow use of these channels.
For instance, if the AP is installed in a challenging indoor environment such as a
warehouse, the administrator may want to allow the AP to use an indoor-only channel.
These channels can be enabled for use through the AP CLI or ZoneDirector web interface
by configuring
Configure
>
System
>
Country Code
>
Channel Mode
and checking
Allow indoor channels (allows ZoneFlex Outdoor APs to use channels regulated
as indoor use only
. If you have a dual-band ZoneFlex Indoor AP functioning as a RAP
with dual-band ZoneFlex Outdoor APs functioning as MAPs, the mesh backhaul link
must initially use a non-indoor-only channel. Your ZoneFlex Outdoor MAPs may fail to
join if the mesh backhaul link is using a restricted indoor-only channel.
Changing the System Log Settings
ZoneDirector maintains an internal log of current events and alarms. This file has a fixed
capacity; at a certain level, ZoneDirector will start deleting the oldest entries to make
room for the newest. This log is volatile, and the contents will be deleted if ZoneDirector
is powered down. If you want a permanent record of all logging activities, you can set
up your syslog server to receive log contents from ZoneDirector, and then use the web
interface to direct all logging to the syslog server.
Reviewing the Current Log Contents
1.
Go to
Monitor
>
All Events/Activities
2.
Review the events and alarms listed below. Log entries are listed in reverse
chronological order (with the latest logs at the top of the list).
3.
Click a column header to sort the contents by that category.
4.
Click any column twice to switch chronological or alphanumeric sorting modes.
57
Ruckus Wireless ZoneDirector™ Release 10.0 User Guide
Configuring System Settings
Changing the System Log Settings
