![Ruckus Wireless ZoneDirector 1200 User Manual Download Page 305](http://html1.mh-extra.com/html/ruckus-wireless/zonedirector-1200/zonedirector-1200_user-manual_1498797305.webp)
Recommended Action
Description
Status
AP is connected to
ZoneDirector via its Ethernet
port, but acts as a Mesh AP
using another Mesh AP as
its uplink
Connected (eMesh AP, n
hops
• The AP may be
configured incorrectly.
Verify that the mesh
SSID and passphrase
configured on the AP are
correct.
• If Uplink Selection is set
to Manual, the uplink AP
specified for this AP may
be off or unavailable.
AP is disconnected from the
ZoneDirector mesh
Isolated Mesh AP
Using the ZoneFlex LEDs to Determine the Mesh
Status
In addition to checking the mesh status of ZoneFlex APs from the ZoneDirector web
interface, you can also check the LEDs on the APs. The LED behaviors that indicate the
AP's mesh status vary depending whether the AP is a single-band or a dual-band model.
On Single-band ZoneFlex APs
On single-band ZoneFlex APs (for example, ZoneFlex 7352), the two LEDs that indicate
the mesh status are:
• WLAN (Wireless Device Association) LED - Indicates downlink status and client
association status
• AIR (Signal/Air Quality) LED - Indicates uplink status and the quality of the wireless
signal to the uplink AP
305
Ruckus Wireless ZoneDirector™ Release 10.0 User Guide
Deploying a Smart Mesh Network
Using the ZoneFlex LEDs to Determine the Mesh Status