Get a Quick Start
MediaFlex Router
g
D E F A U L T S
Network name
V54-xxxxxx (provider)
(where xxxx is the last 6-digits of MAC address)
V54-HOME001 (user)
Security
WPA-PSK (provider SSID)
Disabled (user SSID)
IP addressing
192.168.1.1 (router LAN ports)
192.168.0.1 (router WAN port)
192.168.0.254 (adapter)
Username/Password
u/n: super p/w: sp-admin (provider)
u/n: admin p/w: password (user)
Power
Indicator
WAN
Connectivity
WLAN
Device
Association
Signal
Quality
Your Mediaflex router has a
basic default configuration
for auto-provisioning process
described below. However,
if you wish to change any of
the default parameters (SSID,
encryption type, encryption
key, password etc.), you must
configure the Mediaflex router
before performing the auto-
provisioning set-up
(see User Manual).
L E D G U I D E
(complete explanation of LED behavior in User Manual)
Power on
WAN connected
green=100 Mbps
amber=10 Mbps
No associated
devices
Device(s)
associated
Associated station
with lowest signal
strength connected
perfectly
Associated station
with lowest signal
strength connected
OK
Associated station
with lowest signal
strength connected
poorly
Hardware problem
Blinking
Blinking
g
Adapter
Router
When autoprovision
complete, disconnect cable
Autoprovisioning
in process
Autoprovisioning
complete
ADAPTER LEDs
2 right LEDs are blinking
2 right LEDs are off
Amber
Green
Green/Amber
Green
Green
Green
Green/Red
Red
F O R T H E S E R V I C E P R O V I D E R
Plug in A/C adapters and connect
to Ruckus router and adapter.
Autoprovision by directly connecting Ruckus router
to Ruckus adapter with an Ethernet cable (supplied)
Plug one end of the Ethernet cable into LAN port
of DSL modem or broadband gateway and the
other into the WAN port of the MediaFlex router
Attach Ruckus adapter to receiving devices
(eg. set top box, game machine, computer, etc.),
turn on TV
to ensure connectivity and
(optional)
turn on wireless
laptop to connect o the Internet
062906
1
2
3
4
If you have PPPoE service
turn over for instructions
