16
Ruckus ICX 7850 Switch Hardware Installation Guide
Part Number: 53-1005580-01
Mounting the Device
Installing the Device on a Desktop
Installing the Device on a Desktop
Complete the following steps to install the Ruckus ICX 7850 on a desktop or other flat surface.
FIGURE 6
Attaching the Adhesive Feet
1.
Attach the four adhesive feet to the bottom of the device.
2.
Set the device on a flat desktop, table, or shelf near an AC power source. Make sure that adequate ventilation is provided for the
system. A 7.62 cm (3-inch) clearance is recommended on each side.
3.
If installing a single device only, go to
“Providing Power to the Device”
.
4.
If installing multiple devices, attach the adhesive feet to each device. Place each device squarely on top of the one below.
Installing the Device in a Rack
NOTE
You need a #2 Phillips screwdriver for installation.
CAUTION
Use the screws specified in the procedure. Using longer screws can damage the device.
CAUTION
Do not install the device in an environment where the operating ambient temperature might exceed 50°C (122°F).
CAUTION
Make sure the rack housing the device is adequately secured to prevent it from becoming unstable or falling over.
