Date:
09-May-2019
Product name
RTX2018
File
: RTX2018 User Manual 1.0.docx
Ref.: FHA
Page: 18 of 34
This document and the information contained is property of RTX A/S, Denmark, and should be regarded as confidential.
Unauthorized copying is not allowed. The information in this document is believed to be correct at the time of writing. RTX A/S
reserves the right at any time to change said content, circuitry and specifications.
5.2.2
Manual DUT Control
If the “Manual” button is pressed
(see Figure
7
7 below)
in the “DUT Interface” area
, the DUT
control functionality is disabled.
Figure 7. RX tab in manual DUT mode
This means that the only operation possible in the RX mode is control of the signal that is
transmitted by the CMW100 RF generator. The DUT control
area and the “Measurement area”
will be disabled.
The BER/FER in this case will need to be read out from the DUT by other means (and outside
the RTX2018 application).
5.2.3
RF Generator Setup
The RF generator setup details are shown in Figure 8 below.
The “Modulation
/Waveform
”
field is a drop-down menu used to select which modulation
format (and hence waveform file) for the ARB generator.
If the DUT uses the RTX DA14495 stack, there is a specific waveform file for each modulation
type. This selection is done automatically.
If “Manual” is chosen as
modulation, the user can manually type in the file name to be used.
Please note that the waveform files need to be stored on the PC that is physically connected
to the CMW100 via USB.
The default path to waveform files is:
