RTW 10689, Operating Manual

Page: 179 / 186

RTW DigitalMonitor 8ch 10689 179 Appendix A: Specifications
Appendix A: Specifications
General
Supply voltage: 24 V DC ±10 %
Current drain nominal: 290 mA
Note:
Please note that the momentary switch-on current is considerably higher
than the nominal current!
Operating temperature range: 0° to +45° celsius
Digital inputs: 4 (Stereo), AES-3, transformer balanced
Input impedance: 110 Ω or Hi-Z
Sampling frequency range: 32 kHz to 96 kHz
Digital output: 4 (Stereo), AES3,
input signal looped through, unbuffered
Weight: approx. 750 g net
Connectors: 2 x 25-pin Sub-D-F
1 x 15-pin Sub-D (Remote)
1 x 15-pin Sub-D (VGA)
1 x flange connector type Binder 710 (DC)
Dimensions/weight: 176,5 x 125,5 x 61,5 mm/approx. 750 g
(10689/10689-PLUS without table-stand)
Display
Display: VGA color TFT, 640 x 480 pixel, 132 x 99 mm
Colors: 8
Reversal direction: 12 o’clock
Viewing angle: horizontal 60° typ., vertical 60° typ.
Contrast: 250 at reversal direction
Note:
The built-in display has a high resolution (640 x 480 pixel). Even with the most
advanced techniques, a small number of pixel defects is inevitable. The
manufacturer of the display specifies a maximum of 6 active or passive pixel
defects. RTW guarantees these specifications to be met by their products.
Digital Peakmeter
Level display: up to 8 channels, peak hold indicator
switchable, vertical display orientation
Viewing area: 68 x 98 mm (W x H)
Bargraph length: 90 mm
Display modes: 1 x Stereo, 2 x Stereo, 3 x Stereo, 4 x Stereo
2-channel, 4-channel, 6-channel, 8-channel
Peak value memory: maximum peak level, peak hold
Numeric level display: selectable, shown on the lower left side of
the display
Correlator spot indicator: switchable, in 8-channel mode for up to
stereo channel pairs (at the bottom of each
bargraph pair on the left)
Loudness meter: additional spot indicator displayed on the
bargraphs of the level display, RTW mode
or A-, C-, CCIR-2k weighting, RMS