18 Installation
KP-3016/3016A Series
Bosch Security Systems, Inc.
Technical Manual
F.01U.315.927
Rev. 02
KP-3016/KP-3016A Installation
IMPORTANT:
If you plan to use the Power Supply Mounting Bracket, we recommend you install the mounting bracket
before cabling the keypanel. For information on different power supply mounting options, see “Power
Supply Mounting” on page 159.
IMPORTANT:
When the OEI-2 power supply is used on a KP-3016/3016A keypanel, the following warning blinks to
indicate the wrong power supply being used. The OEI-2 uses less voltage than the keypanel, therefore,
when the power supply for the OEI-2 is used on a keypanel, degraded audio may be heard. No damage
to the keypanel occurs.
To
install the KP-3016/3016A
, do the following:
1.
On the rear panel of the KP-3016/3016A, plug the
24 VDC power connector (A)
of the power supply into the power
connector on the back panel of the unit.
2.
Connect an
RJ-12
or
RJ-45 (568B or USOC) cable
(B)
with RTS cabling to the J8 FRAME connector on the rear
panel.
OR
Connect an
CAT-5e cable (C)
to the J11 ETHERNET connector on the rear panel (only available for the KP-3016)
3.
Once the unit is cabled, plug the
power supply power cord
into the wall outlet or a power strip.
FIGURE 4.
KP-3016/3016A Installation