RTS DV 2055 Series, User Manual

Page: 6 / 22

2
PREPARATION
• Determine the appropriate angle of the transceiver, using the
3 screw hole positions on the side of the mounting bracket.
Mobile installation
To install the transceiver, select a safe, convenient location inside
your vehicle that minimizes danger to your passengers and yourself
while the vehicle is in motion. Consider installing the unit at an
appro-priate position so that knees or legs will not strike it during
sudden bra-king of your vehicle. Try to pick a well ventilated location
that is shielded from direct sunlight.
• The bracket must be installed so that the 3 screw hole positions
on the side of the mounting bracket are towards the rear of the
bracket.
Self-tapping screw (5mmX16mm)
Spring washer
Flat washer
2. Position the transceiver, then insert and tighten the supplied
hexagon SEMS screws and flat washers.
• Double check that all hardware is tightened to prevent vehicle
vibration from loosening the bracket or transceiver.
1. Install the mounting bracket in the vehicle using the supplied self-
tapping screws (4pcs), flat washers (4pcs), and spring washers
(4pcs).