RTS DKP-4016, Technical Manual

Page: 24 / 282

24 Installation DKP-4016
Bosch Security Systems, Inc. Technical Manual F.01U.308.248 Rev. 03
Connecting the DKP-4016/4016W through the OMNEO Offers Menu
IMPORTANT: If you used IPedit to set up the keypanel connection, this step is not needed, because you have already
done this in the software.
To finish the configuration, you must configure the keypanel to talk with the OMI card in the frame. To do this, you must
establish a connection using the OMNEO Offers menu on the keypanel. For more information, see “Menu System, OMNEO
Offers” on page 222.
To configure an available OMNEO device connection port , do the following:
1.
Starting at the OMNEO Offers|Keypanel menu, select OKP .
2.
Press the SEL button .
A list of available OMNEO offers appear .
3.
Using the arrow buttons,

select the OMNEO offer you want to use.
An arrow appears next to the device .
4.
Press the CLR button to exit menu mode.
Power Up
At power-up, if the keypanel is connected to the matrix, the alphanumeric display shows dashes in the light blue color key
. After several seconds, the intercom key assignments display with the appropriate color keys and alphas.
NOTE: If the keypanel cannot establish communications with the intercom system, all alphanumeric displays continue to
show asterisks (****) and the Disconnected from Matrix icon appears in the panel display. If
the keypanel is configured for OMNEO, this icon also displays the OMNEO device name. Check the keypanel to
matrix cable connection if this occurs. If the keypanel loses communications with the intercom, the panel display
shows the Disconnected from Matrix icon and displays the after approximately 30 seconds.