RTS DKP-4016, Technical Manual

Page: 190 / 282

190 DKP-4016 Menu System DKP-4016
Bosch Security Systems, Inc. Technical Manual F.01U.308.248 Rev. 03
Mix Mode
The Mix Mode menu is used to control whether mixes made to the speakers and headsets are muted when they are not active.
Available options for this menu are:
Aux Mixes Switched (default) Aux inputs mixed to matrix out, preamp out, speakers or headsets are only heard
when the panel is in the appropriate headset or speaker mode.
Mixes always active Aux inputs mixed to speakers or headset are always heard, regardless of whether
the panel is in headset or speaker mode.
To configure Mix Mode, do the following:
1.
Starting at the Audio Options|Advanced menu, select Mix Mode .
2.
Press the SEL button .
Aux Mixes Switched and Mixes Always Active appear in the panel display .
3.
Using the left or right arrow buttons, select the mix mode you desire.
4.
Press the SEL button .
An arrow appears next to the selection.
Noise Gate
The Noise Gate menu is used to enable or disable the audio level at which the mic turns on. When noise gate is enabled,
microphone noise gate is set to -72dBu; when the noise gate is disabled, the microphone is always on.
To enable/disable noise gate , do the following:
1.
Stating at the Audio Options|Advanced menu, select Noise Gate .
2.
Using the left or right arrow keys, move to the Mic scroll box .
3.
Using the up or down arrow keys, select the Front Mic , Left Mic , Rear Mic , or Right Mic .
4.
Using the left or right arrow keys, move to the State scroll box .
5.
Using the up or down arrow keys, select Disable or Enable .
Noise Gate – Audio Package Only
If you have purchased the Audio Package for the DKP-4016, you have the ability to adjust the noise gate, giving you more
flexibility configuring the input gate levels for each device.
Available options are: Disabled, -87 dBu, -84 dBu, -81 dBu, -78 dBu, -75 dBu, -72 dBu, -69 dBu, -66 dBu, -63 dBu, -60 dBu, -
57 dBu, -54 dBu, -51 dBu, -48 dBu, -48 dBu, or -42 dBu .
To adjust the noise gate , do the following:
1.
Stating at the Audio Options|Advanced menu, select Noise Gate .
2.
Press the SEL button .
F ront Mic, Left Hdst, Rear Mic, and Right Hdst appear in the panel display.
3.
Using the left or right arrow keys, select the input you want to apply the noise gate.
4.
Press the SEL button .
The Noise Gate scroll list appears in the panel display.
5.
Using the up and down arrow keys, select the gate level you desire.