RTS DKP 16 CLD, User Manual

Page: 187 / 232

KP32CLD 177
Bosch Security Systems, Inc. User Manual F.01U.193.294 Rev. 10
NOTE: Once the Boot Loader is finished downloading, the KP 32 CLD reboots itself. The KP 32 CLD displays one of
two (2) messages shown below. If the download is brand new, message 1 appears. However, if you are
reinstalling the same boot load file on the KP 32 CLD, message 2 appears.
Enable The Boot Loader On The Keypanel (v 1.1.0 and later)
By enabling the boot loader on the keypanel, updating the firmware on the keypanel is simple. Once you have enabled the
keypanel to allow the firmware to be downloaded to it, you can use AZedit to do the rest of the work.
NOTE: If the keypanel is powered off or loses power, the state of the Allow Download option resets to not enabled. You
must reconfigure the option for it to allow downloads.
To enable the boot loader on the keypanel , do the following:
1.
While pressing the Main Vol and Aux Vol encoders at the same time, press the MENU button.

The main menu appears.
2.
Using the 3(

) or 6(

), select Service .
3.
Press the SEL button.

The Service menu options appear.
4.
Using the 3(

) or 6(

), select Boot Code .
Message 1
Message 2