RT-2M (90007891000) Quick Start Guide
NOTE:
See the entire system diagram on reverse side.
RS-232 Cable Pinout
Step 1.
Cable the Trunk Supervisor/TrunkEdit PC to the
RT-2M.
NOTE:
In Trunk Supervisor, you must designate
the intercom and port number the RT-2M
sends the test signal over.
To
cable the Trunk Supervisor/TrunkEdit PC to the
RT-2M
, do the following:
1.
Using the included cable, connect a
COM port
on
the Trunk Supervisor computer to the
RS-232
Interface
connector
on the rear panel of the RT-2M.
Step 2.
Cable the RT-2M to the Frame.
To
cable the RT-2M to the Frame
, do the following:
1.
Using the appropriate connector defined below, connect the
RT-2M
to the Frame:
2.
Connect the
other end of the connector
to the trunking
connection port as defined in the Trunk Supervisor software.
CONNECTOR
CONNECTION
RJ-12
•
Plug
pins 2
and
5
into the Ch 1 input connector terminals.
•
Plug
pins 3
and
4
into the Ch 1 output connector terminals.
DB-9
•
Plug
pins 7
and
8
into the Ch 1 input connector terminals
•
Plug
pins 4
and
5
into the Ch 1output connector terminals.
INCLUDED PARTS:
•
RT-2M Unit
•
DB-9 Cable
LIT000306000 Rev. A
11/2008
