32 Initial Equipment Setup
BTR-800, TR-800, TR-825
Beltpack Setup
Battery Installation
Ensure that the On/Off volume control knob is turned off. Press
down and hold down the battery release latch, slide the battery
pack about 1/8-inch back, toward the latch, until it stops. Then
lift the battery pack out. Replace the batteries as follows:
1.
Open the battery pack by inserting finger nail and lifting.
2.
Pull battery strap to remove low or dead batteries.
3.
Load new batteries following the polarity, as shown in the
battery case.
4.
Start loading at the end of the case where the strap is
attached to the case.
5.
Be sure the strap goes under the batteries.
6.
Tuck end of strap under door when placing the battery
cover back on the case.
FIGURE 31.
Battery Installation
WARNING:
Do not place an alkaline TR battery pack
in any battery charger. Severe charger and
battery pack damage may result.
7.
For the TR-825, ensure that both On/Off volume control
knobs are turned off prior to inserting the battery pack onto
the TR-825 to prevent the possibility of a voltage spike that
could the unit to become inoperable.
Summary of Contents for BTR-800
