18 Initial Setup and Configuration
Universal Beltpack – BP-6000
Setup Mode Indication
When power is applied to beltpack, the LED lights blink to indicate the setup mode it is currently
running.
Audiocom –
LEDs blink six times in three seconds
Clear-Com –
LEDs blink nine times in three seconds
Firmware Version
Knowing the version of firmware running on the beltpack can assist a service technician to better
troubleshoot problems on the beltpack, if needed. When the beltpack has power applied to the unit while
pressing the TALK button, a voice prompt is heard in the headset saying the firmware version currently
installed.
To
check the firmware version of the beltpack
, do the following:
1.
Verify the
beltpack does not have power connected
.
2.
While pressing the TALK button, plug the
power cable
from the power supply or powered
network to the Intercom Channel Connector located on the bottom plate of the beltpack (see
Figure 1 on page 8).
[voice prompt] “X.X.X “(where X represents the firmware version).
Summary of Contents for BP-6000
