110
Output card channel does not respond to remote input change
Possible cause:-
Output channel remote mapping is not selected.
Solution:-
Select remote mapping by following instruction in the configuration manual.
Possible cause:-
Output channel is incorrectly I/O mapped.
Solution:-
Refer to configuration manual for information on I/O mapping.
Input Card fails to sign on
Refer to trouble shooting heading – “Status Led on some input cards fail to illuminate”
Output Card fails to sign on
Refer to trouble shooting heading – “Status Led on some output cards fail to illuminate”
Relay Card fails to sign on
Refer to trouble shooting heading – “Status Led on some relay cards fail to illuminate”
Sustained watchdog relay fault
Possible cause:-
Card not signed on.
Solution:-
Refer to trouble shooting heading – “Status Led on some input cards fail to illuminate”
Refer to trouble shooting heading – “Status Led on some output cards fail to illuminate”
Refer to trouble shooting heading – “Status Led on some relay cards fail to illuminate”
Possible cause:-
9000TS system structure is modified when a watchdog error existed. Watchdog faults,
events, status block entries cannot be cleared in the normal way if the card that created the
record no longer exists in the system structure.
Solution:-
Restore the original 9000TS system structure using the configuration software or remove
and refit the interface card battery; this will clear all records including outstanding events.
Intermittent watchdog relay fault
Possible cause:-
Input card has address set incorrectly.
Solution:-
Remove card and check / change address settings on 8way switch as per user instructions.
Replace card and check if status Led illuminates.
Possible cause:-
Output card has address set incorrectly.
Solution:-
Remove card and check / change address settings on 8way switch as per user instructions.
Replace card and check if status Led illuminates.