RTI TheaterTouch T2, User'S Manual And Programming Manual

Page: 15 / 118

Chapter 2 • Introduction
5
BATTERIES AND CHARGER
The following recommendations will assure the best battery performance.
1. Operate the unit until you receive a Low Battery warning in the upper left
hand corner of display.
2. At that point, you will have approximately 10 - 20 minutes of run time
remaining before the unit shuts down. At any point after the Low Battery
icon appears, you can exchange the depleted battery with a charged battery
from the charger. If you operate the battery past a usable level, you will
receive a warning stating
Battery must be recharged .
To recharge a battery pack, insert the end of the battery with the contacts into the
charger first, and then gently pushing the end with the clip until it snaps into place.
The light on the charger will start flashing after a couple of seconds.
Charging Status
Light
(1)
(2)
Recharge the TheaterTouch batteries for about 3-4 hours. (The light on the battery
charger will stop flashing and stay on when the charge cycle is completed).
The batteries can remain in the charger indefinitely without damage to the batteries.