Seat Section Assembly
1
(2) 1/4”x 2-1/4” Clevis Pins
(2) 1/4”x 3” Clevis Pins
(2) 5/16”x 3-1/4” Clevis Pins
(2) Stop Pins
(6) Hair Pins
(30) Screws
(8) Wood Screws
FIRST: Be sure to correctly identify the
5
Seat Slats (holes are closer together and
will align with the faceplate) and the
5
Back Slats.
H A R D W A R E
A S S E M B L Y
B.
B.
B.
B.
B.
Position the (2) Back Legs as shown with Stop Pins pointing
in toward each other. Attach (3) Single-Hole and (2) Double-
Hole Back Slats to each Back Leg using (7) Screws per Leg.
AGAIN, DO NOT TIGHTEN.
Wheel
Seat Leg
Attach this Single-Hole Seat Slat LAST.
Faceplate
Hair
Pin
Seat Slats
Short
Clevis
Pin
Back Leg
Back Slats
Stop Pins
must face
inward and
opposite of
each other.
A.
A.
A.
A.
A.
Position the two Seat Legs as shown. Using the hex
wrench provided, attach (3) Single-Hole and (2) Double-
Hole Seat Slats to each Seat Leg using (7) Screws per leg.
DO NOT TIGHTEN SCREWS YET.
C.
C.
C.
C.
C.
Attach the (2) Plastic Wheels to the inside of each Seat Leg
by inserting a Short Clevis Pin thru the leg from the outside,
slip on the Wheel and secure with a Hair Pin.
B.
B.
B.
B.
B.
Now attach Faceplate (shorter board) to the front of each
Seat Leg using (2) Screws.
Insert
Stop Pins
with slot
facing in
direction of
arrows.
Patent #5,170,519
A S S E M B L Y
I N S T R U C T I O N S
(2) Wheels
(2) Washers
(1) Hex Wrench
(4) Edge Trim
Helpful
Hints:
The
only
tools
you
will
need
are
a
Hammer
and
a
Phillips
Head
Screw-
driver.
To
make
assembly
easier,
rub
the
threads
of
the
wood
screws
on
a
bar
of
soap.
This
is
a
carpenterís
trick
that
really
works
great!
A.
A.
A.
A.
A.
Lay the (2) Back Legs down
exactly as shown at left. Insert a
Stop Pin in each Back Leg,
positioning each so that the slot
in the Stop Pin faces in the direction
of the arrows. Use a hammer to fully
insert Pin (Pin should be flush with
other side of Leg).
Back Section Assembly
2
(2) Back Legs
(2) 1/4” x 2-1/2” Clevis Pins
2-1/2” Clevis Pin thru the leg from the outside,
