Real Time Automation, Inc.
30
1-800-249-1612
8)
Bit Pack:
Select the formatting of the Coil Status/Input Status. Automap will use this packing size to
map coils to/from the other protocol. The bit pack selection here should match that of the other
protocol. The starting address is considered Bit 0 and is the low-order bit.
9)
To enable data swapping, select the required
Swap Indicator
. If the bytes appear in the wrong
order, enable swapping to change the data. This swapping does
NOT
change coils and their ordering
inside the Bit Pack.
10)
Enter the number of read scan lines and write scan lines.
11)
Click the
Generate Scan Lines
button to have the read and write scan lines auto-generate for you.
You may manually configure the read and write scan lines after they have been generated.
