Lift & Level Kit
Installation Instructions
2011-2018 WK Grand Cherokee
Part #: RT21054
Kit Contents
- Front Strut Spacer
Qty: 2
- Rear Coil Spring Spacer
Qty: 2
- Rear Shock Absorber Spacer
Qty: 2
- 1/4" Thick Flat Washer
Qty: 2
- 1/2"-13 x 4” Grade 5 Bolt
Qty: 2
- M10-1.5 x 50mm Class 8.8 Bolt Qty: 4
- 1/2" Flat Washer
Qty: 2
- M10 Split Lock Washer
Qty: 4
- M10 Flat Washer
Qty: 4
- M8 Flat Washer
Qty: 6
- M8-1.25 Nylon Locking Nut
Qty: 6
Required Tools
- 10mm Socket and/or Wrench
- 19mm Socket and/or Wrench
- 32mm Socket
- Pliers
- 13mm Socket and/ or Wrench - 21mm Socket and/or Wrench
- Screwdriver
- Ft. Lb. Torque Wrench
- 16mm Socket
- 22mm Socket or Lug Wrench
- Pry Bar
- In. Lb. Torque Wrench
- 18mm Socket and/or Wrench
- 24mm Socket and/or Wrench
- Hammer
NOTE: This kit is designed to work only on vehicles equipped with coil springs. It will NOT fit vehicles
equipped with Quadra-Lift Air Suspension.
Ensure that all components in kit are accounted for.
Front Installation
1.
Open the hood. Place wheel chocks against the rear tires. Lift the vehicle by the front lower control arms, support
the vehicle with jack stands at the frame, and remove the wheels using a 22mm socket.
2.
Place a jack under the lower control arm. Raise the suspension a few inches to relieve stress or binding. Raising or
lowering the suspension will help in removing or installing components throughout the installation of this kit.
3.
Remove the wheel speed sensor from the knuckle using a 10mm socket or wrench. Retain the hardware for re-
assembly.
4.
Remove the caliper bracket from the knuckle using a 21mm socket or wrench. Retain the hardware for re-
assembly. Ensure the caliper doesn’t hang from the brake hose.
