63
AUX, MTX, MAIN operations
AUX, MTX, MAIN operations
1.
In the fader module section, press [SEL] to select channel.
Each time you press the MAIN [SEL], it will select the MAIN L, MAIN R,
or MAIN C one after another.
2.
In the CHANNEL EDIT section, press [CH DISP] to access
the CHANNEL DISPLAY screen.
fig.ScrChAux.eps
By pressing a different [SEL] while the CHANNEL DISPLAY screen is
shown, you can switch to the display for that channel.
If you’ve selected the “CHANNEL DISPLAY follows CH SELECT”
button located in the CHANNEL SELECT area of User Preference
(p. 137), pressing a [SEL] will recall the CHANNEL DISPLAY screen
for that channel.
You can stereo-link adjacent odd-numbered and even-numbered
AUX/MTX so that their parameters will have the same settings.
This is convenient when you want stereo output.
1.
Access the CHANNEL DISPLAY screen for the AUX/MTX
that you want to stereo-link.
fig.ScrChAux.eps
2.
Press [F1 (LINK)].
fig.ScrAuxLinkConf.eps
A confirmation message will appear, asking you to confirm
the stereo-link operation.
The function buttons have the following operations:
3.
Press [F7 (LINK (L <- R))] or
[F8 (LINK (L -> R))]
, the AUX/
MTX will be stereo-linked.
Stereo-link will link the following parameters:
• Attenuator
• Limiter parameters
• 8-band EQ parameters
• Fader parameters
• MAIN send level, send switch, and send point
• MTX send level, send switch, and send point
• DELAY
MAIN L/R is always stereo-linked.
When linked, the limiter will operate in stereo.
Accessing the CHANNEL DISPLAY screen
Stereo-linking AUX/MTX
[F6 (CANCEL)]
Cancels the stereo-link operation and closes
the popup.
[F7 (LINK (L <- R))]
The parameters of the odd-numbered channel
will be set to the values of the even-numbered
channel.
[F8 (LINK (L -> R))]
The parameters of the even-numbered channel
will be set to the values of the odd-numbered
channel.
About linked parameters
M-300_e.book 63 ページ ２０１０年４月２２日 木曜日 午前８時１７分
